$274.95
Large Arbor Reel for 6-8 Weight (TFR 340)
Product Description
Care & Maintenance
Spool & Frame Finish
Anodized aluminum reels are extremely corrosion resistant but should be rinsed with fresh water after exposure to saltwater to help protect them. Warm water and a toothbrush can be used to dissolve any salt buildup, which may be in the reel. Anti-corrosive products such as spray polishes, and oils etc. are not required, but may preserve the long-term aesthetics of the reel.
Lubrication
High quality grease, such as Cal’s 2 Speed, should be periodically applied to:
1. The threads on the draw bar
2. All bearings
3. The spindle where it contacts the bearings within the spool
Drag Surface
Carbon Fiber drags do not require any lubricant, but a very thin coat of Cal’s 2 Speed is beneficial.
Removing the Spool
Tools Required: None
Loosen the drag completely then turn the spool cap assembly (center of the spool) counter clockwise until the spool is free.
Reversing the Retrieve
Follow procedure above for removing the spool. Slide the carbon fiber drag assembly off of the spindle (310 & 340 models require the removal of an e-clip), slide the one-way roller bearing out of the drag assembly and rotate 180 degrees (blue on top for right hand retrieve). Re-assemble.
Spool & Frame Finish
Anodized aluminum reels are extremely corrosion resistant but should be rinsed with fresh water after exposure to saltwater to help protect them. Warm water and a toothbrush can be used to dissolve any salt buildup, which may be in the reel. Anti-corrosive products such as spray polishes, and oils etc. are not required, but may preserve the long-term aesthetics of the reel.
Lubrication
High quality grease, such as Cal’s 2 Speed, should be periodically applied to:
1. The threads on the draw bar
2. All bearings
3. The spindle where it contacts the bearings within the spool
Drag Surface
Carbon Fiber drags do not require any lubricant, but a very thin coat of Cal’s 2 Speed is beneficial.
Removing the Spool
Tools Required: None
Loosen the drag completely then turn the spool cap assembly (center of the spool) counter clockwise until the spool is free.
Reversing the Retrieve
Follow procedure above for removing the spool. Slide the carbon fiber drag assembly off of the spindle (310 & 340 models require the removal of an e-clip), slide the one-way roller bearing out of the drag assembly and rotate 180 degrees (blue on top for right hand retrieve). Re-assemble.
Additional Information
| Capacity | 150 yards/ 20lb./ WF8F |
Product Tags
Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.